Honeywell Water Heater Gas Valve Pilot Won T Stay Lit

If your gas water heater doesn t stay lit you may have a defective control thermostat.

Honeywell water heater gas valve pilot won t stay lit.

If your gas water heater doesn t stay lit you may have a defective control thermostat. Thankfully a dirty pilot tube is the easiest issue to fix. The gas supply to the pilot assembly is controlled by this valve. If the pilot light won t stay lit and the thermocouple is okay then the thermostatic control valve may be defective.

If you don t see a spark at all when you are trying to light your pilot it may be that you are not looking in at the right angle. This is also a likely cause if the pilot won t ignite at all. Replacement of this part should be. Yes if the thermopile is bad then the pilot will not stay lit when you let go of the button.

It is almost certainly the valve is bad and not opening or the fuel is restricted by debris or dirty fuel filter from the tank. You have to put your ear down to the floor to see the pilot. The air intake is located on the bottom or side of the water heater and may need to be cleaned out in order for the pilot to stay lit. Replacement of this part should be.

A thermocouple senses the heat of the pilot and allows gas to flow to the burner. A bad thermocouple will shut off gas to both the pilot and the. Another possible reason why a pilot won t stay lit has to do with the flex tubing. If this is the problem then unkinking the tube will occasionally resolve the issue.

The gas supply to the pilot assembly is controlled by this valve. Here s a solution for your hot water tanks that won t stay lit. This tubing connects to the gas controller and will ensure a steady stream of gas. Replacement is an easy diy repair.

There are other tanks that have light sensors flame sensors and someone if that s yours th. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature. Sometimes this tubing will get kinked in places which will prevent proper operation. If your hot water heater suddenly stops working chances are a bad thermocouple has shut off the gas to the pilot light.

Dirt and debris can collect in the pilot tube causing the flow of gas to be blocked. This control is part of the gas valve assembly and normally has a dial that will allow for temperature adjustment and will also have a probe that monitors the water temperature. If the pilot light won t stay lit and the thermocouple is okay then the thermostatic control valve may be defective. The chimney has been cleaned and the door to the furnace room read more.