Honeywell Water Heater Pilot Light Won T Light

This valve has a indicator light that blinks after the about 30 seconds of the pilot being lit.

Honeywell water heater pilot light won t light.

Want to say thanks for the video. You can usually replace a thermocouple for minimal cost and in less than an hour. If the pilot doesn t relight if it goes out right after lighting or if the pilot light keeps going out by far the most common cause is a bad thermocouple. The pilot light in your hot water heater does more than simply ignite the gas.

Some rheem water heater pilot problems are easier to diagnose than others. Then it is ready to turn the button to burner. The air intake is located on the bottom or side of the water heater and may need to be cleaned out in order for the pilot to stay lit. Although a blocked gas line is one reason why the pilot light on a rheem water heater won t light or stay lit there are other reasons as well some easier to correct than others.

Pilot light issues are some of the most common problems experienced with gas water heaters. A bad thermocouple will shut off gas to both the pilot and the burner which is when people notice that the water heater pilot light is out. Not only does it prevent a furnace from operating properly but an unlit pilot can also steal away the comforts of a hot morning shower. When the water heater pilot light goes out first try relighting it following the directions on the water heater label.

If you smell gas do not attempt to light the heater. A pilot light that won t stay lit is more than frustrating. It is located near the bottom of the tank. It s free for you to use and amazon pays a small commission https amzn to 33i9exy in this vid.

You have to put your ear down to the floor to see the pilot. Unfortunately there are a variety of reasons why pilot lights go out all of which are dependent on a number of factors. If the smell does not dissipate replace the heater s control valve before proceeding. If you don t see a spark at all when you are trying to light your pilot it may be that you are not looking in at the right angle.

You ll get your hot water going without waiting for a pro to show up and save the cost of a service call for a gas. When your thermocouple detects an unlit pilot it automatically shuts off the gas to your water heater as a safety precaution. Use my amazon link to shop. A faulty thermocouple or malfunction of the gas valve could be the culprit but the problem may be as simple as a draft coming from a crack in the wall or under the door.

The control valve is the box located by the access cover. There is no power to check since the pilot barely comes on and won t even light with the igniter.