How To Secure Vinyl Siding

Using screws allows you to periodically take apart the downspout to clean it which will.

How to secure vinyl siding.

Nail in the center of the nailing slots. To seal the edge of a siding panel where it has been cut and to secure it to the wall you can use under sill trim. Screw fasteners can be used if the screws do not restrict the normal expansion and contraction movement of the vinyl siding panel on the wall. When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion.

Last reattach the vinyl siding. Secure the panels with a nail every 16 inches 40 6 cm or so remembering to center the nail in slot and leave 1 16 of the nail head above the vinyl siding to allow for movement and expansion. In the case of installing a downspout onto vinyl siding a metal screw is used to secure it to the house. This can cause panels to chip or crack if left unattended.

Push up gently until you hear a click. Diy how to fix loose vinyl siding with a malco sideswiper siding tool. Once it is in place test by sliding the last piece back and forth slightly. Be sure to leave about 1 8 of the nail exposed to allow the siding to flex during warmer or colder weather.

Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion. By using a vinyl siding removal tool you can guide loose panels back into place. Be sure the top and bottom click into place. Over time vinyl siding panels can become loose.

Screws must be centered in the slot with approximately 1 32 0 8mm space between the screw head and the vinyl.